1000W 24V 3-Phase AC Wind Power Grid-Tie Inverter | Limiter Sensor + Dump Load | VDE

Compact Grid Feed-In Control for 3-Phase Wind Generators

The 1000W 24V 3-Phase AC Wind Power Grid-Tie Inverter is designed to convert energy from compatible 3-phase AC wind generators into clean AC power for grid feed-in systems. Equipped with a limiter sensor and built-in dump load controller, this inverter supports efficient power conversion, system protection and controlled wind energy management.

With VDE certification, pure sine wave output and integrated safety functions, the system is engineered for reliable grid-connected operation when installed according to the correct electrical and regulatory requirements.

Designed for Direct 3-Phase AC Wind Input

This inverter is designed for direct connection to compatible 24V 3-phase AC wind generators within the required voltage range. The integrated MPPT function helps optimise energy conversion, while the built-in dump load controller helps regulate turbine voltage and protect the system during strong wind conditions.

Important: DC power input is not permitted. This inverter must be used only with compatible AC wind generator output according to the technical specifications.

Key Features

• 1000W grid-tie wind inverter
• Designed for compatible 24V 3-phase AC wind generators
• Includes limiter sensor
• Built-in dump load controller
• VDE-certified system design
• Pure sine wave AC output
• MPPT efficiency up to 99%
• Peak output efficiency up to 92%
• Power factor: 0.99
• Supports AC-side parallel connection
• Island protection
• Overcurrent protection
• Overtemperature protection
• Reverse polarity protection
• Short-circuit / overload protection
• Stackable system design
• Optional WiFi communication with additional WLAN module
• Each inverter is factory tested before dispatch
• 2-year warranty and technical support

Built-In Dump Load Protection

The built-in dump load controller helps maintain wind turbine voltage within the inverter’s rated operating range. In strong wind conditions, the dump load system supports safe voltage regulation and helps protect the inverter from excessive input.

If the wind turbine voltage exceeds the safe operating range, the protection system can disconnect from the turbine to help prevent damage and maintain safe operation.

Limiter Sensor Function

The included limiter sensor helps monitor power flow and supports controlled feed-in behaviour depending on the installation setup. Correct installation and configuration are essential for safe and compliant operation.

Grid connection requirements may vary by country or region. The system must be installed according to local electrical regulations.